Size 1400 mm - 3200 mm with mounting corner
S - Rotors (segmented rotors)
B - Casing (divided casings)
Final assembly at the application site:
Delivery of a rotorsystem comes in three parts:
- Casing bottom part with premounted rotor half, pre-mounted motor block and inspection openings on both sides (R).
- Encasing top part with mounting corner (M), 2 side panels
- Segments still to be mounted.
Detailed assembly instructions are included with the shipment papers.
The casing top part is mounted on the lower casing according to the respective markings.
To complete the mounting of the rotorsystem, the mounting corner M is screwed out.
The segments are mounted one after the other according to the labelling. After that the mounting corner is reinserted.After the V-belt has been mounted and the speed regulation device has been connected, the side panels are mounted and the seals are adjusted. The rotorsystem is ready for operation.
Segmented rotary heat exchangers can be ordered and delivered with pre-assembled rotor halves or without pre-assembled rotor halves.
Pre-assembled rotors shorten and simplify assembly at the end-use site.
An order with a pre-assembled rotor half should, however, only take place if it can be ensured that the pre-assembled rotor can be carefully transported to the end-use location. Shocks and impacts must be avoided, the component must not be tilted and should always be supported in the middle!
If the transport situation is unclear or problematic, the rotary heat exchanger must be ordered without a pre-assembled rotor half.
Please do not hesitate to contact us in order to clarify the best possible solution for your application.